- 电源机架带有线性调节的低噪声电源
- 低噪声和漂移电流,温度和压电驱动器
- 支持众多用于激光稳定的模块
- 用于驱动和锁定各种激光系统的模块化设置
- 所有重要控件都可以直接从模块前面访问
二极管激光器电源机架DC 110是 SYS DC 110系列所有插入式模块的通用基础。它通过集成背板提供必要的电源电压和HV电压,以及通信线路。二极管激光控制器的监视单元DC 110 / Mon可以一目了然地显示出相关的激光参数,最多可显示三个激光系统。
DCC 110模块是低噪声模拟电流控制模块。四种不同的型号可提供高达100 mA,500 mA,3000 mA和5000 mA的电流。 DTC 110是一种低噪声温度控制模块,可精确调节激光二极管的温度 至 1 mK。特殊型号可用于DFB二极管和调节非线性晶体的温度。 SC 110被用于优化驱动ECDL,DFB或扫描法布里-珀罗干涉仪。可将其配置为HV(150 V)或LV(24 V)模式。 “前馈”功能可在压电扫描期间控制二极管电流,以最大化ECDL系统的无模式跳变调整范围。计算机模拟接口DCB 110允许直接访问电源机架DC 110的底板以控制已安装的模块。
- Specifications
- DC 110 - Diode Laser Supply and Control Rack
DC 110 - Diode Laser Supply and Control Rack Model DC 110/19" DC 110/19" DS DC 110/19" DS HP Space available 84 HP 84 HP x2 84 HP x2 Power requirements Typ < 120 W max. 300 W max. 600 W Size (H x W x D) 150 x 465 x 385 mm³ 280 x 465 x 385 mm³ Voltage requirements automatic detection (100 - 120 or 220 - 240 VAC, 50 - 60 Hz) Operating temperature 15 .. 30 °C Transport temperature 0 .. 40 °C - DC 110/Mon - Monitor Unit
DC 110/Mon - Monitor Unit Display Four line LCD dot matrix Control Control wheel for display configuration Channels Up to three diode lasers supported Safety Safety key switch, door interlock safety button to start/stop emission Width 20 HP (102 mm) - DCC 110 - Current Controllers
DCC 110 - current controllers Model DCC 110/100 mA DCC 110/500 mA DCC 110/3 A DCC 110/5 A Output current range 0 .. ± 100 mA 0 .. ± 500 mA 0 .. - 3 A 0 .. - 5 A Constant current mode ✔ ✔ ✔ ✔ Constant power mode ✔ ✔ ✔ ✔ "current modulation bandwidth (-3 dB)" 7 kHz 7 kHz 7 kHz 7 kHz Current clip protection ✔ ✔ ✔ ✔ Voltage clip protection ✔ ✔ ✔ ✔ "RMS wideband noise and ripple (5 Hz .. 1 MHz)" 200 nA 1 µA 10 µA 40 µA Width 12 HP (61 mm) 12 (61 mm) 12 (61 mm) 32 HP (163 mm) - DTC 110 - Temperature Control Module
DTC 110 - Temperature Control Module Model DTC 110 30W DTC 110 TO3 DTC 110 SVL Intended use ECDLs DFBs Crystals Max. TEC current 2.5 A 5 A 5 A Temp. Selection range 0 - 50 °C 0 - 50 °C 25 - 75 °C Over/under temp. protection ✔ ✔ ✔ Controlled heating/cooling ramp ✔ Width 12 HP (61 mm) Max. Power 30 W Long term stability (typ) 1 .. 2 mK - SC 110 - HV Scan Generator
SC 110 - HV Scan Generator Maximum output amplitude + 24 V (LV mode)
+ 150 V (HV mode)Scan frequency range 0.01 Hz - 10 kHz Output offset range -12 V .. +12 V (LV mode)
-5 V .. + 150 V (HV mode)Signal shape sawtooth, symmetric or asymmetric ramps, variable Trigger input / output TTL, adjustable time delay Feed Forward Simultaneous control of grating angle and laser current, adjustable ratio - DCB 110 - Analog Control Interface
DCB 110 - Analog Control Interface Current input sensitivty 10 mA/V (DCC 110, 100 mA and 500 mA), 100 mA/V (DCC 110 / 3 A) Temperature input sensitivity 10 deg C/V (DTC 110) Auxiliary supply voltages ± 12 V, ± 5 V, GND (DCB 110 AUX only) Connectors Sub-D25 connector, additional BNC connector to access selected backplane line Width 4 HP (20 mm)
- DC 110 - Diode Laser Supply and Control Rack
- Applications
Atom and Ion cooling and trapping
Bose-Einstein Condensation & degenerate Fermi gases
Quantum Optics
Metrology
Spectroscopy - Related Products
- DLC pro: all digital, convenient ultra-low noise & drift control electronics
- DL pro
- TA pro
- Frequency converted diode lasers
- Downloads
Brochure: Scientific Lasers
Brochure: Laboratory Electronics